Lock Out, Tag-out abbreviated as
LOTO is usually a safety procedure widely used in industry and research
settings to make sure that hazardous machines are properly turned off and are
not able to start again until or unless maintenance or repair work has been
executed properly.
What kind of energy sources should be controlled by using
lockout tag out?
All energy sources of hazardous
nature must be controlled. This usually includes:
●
Electrical
●
Mechanical
●
Hydraulic
●
Pneumatic
●
Chemical
●
Thermal
●
Other energy sources
The law requires that workers
follow safe work practices, which usually includes using proper lockout tag-out
procedures. Lockout tagout training Ontario
helps to understand the safety measures you should take before operating this
equipment. These requirements are usually in effect anytime an employee is
prone to electrical hazards when working on, near, or with conductors or
systems that generally use electric energy.
What do employees must know?
Your lockout tag out course must
ensure that employees know, understand, and follow the required provisions of
the hazardous energy control procedures.
The training must cover the
minimum:
●
Different aspects of
your energy control program
●
All elements of the
energy control procedure that are relevant to each employee’s duties or assignment
●
The different
requirements of the OSHA standards related to lockout tagout certification
Key aspects that should be taken care of by the employer
Any procedure the employer
conducts in regards to a lockout tag out program should be documented for when
workers are actively indulged with machines or equipment where lockout tag out
is usually used. When developing your procedures for lockout tag out you must
ensure to include the following:
●
The particular use and
purpose of the procedure
●
All steps to shut
down, disconnect, and safeguard the machine to prevent startup
●
Individual labeling of
each lockout tag out device
●
Devices must endure
the environment they are used in, usually including potentially different
weather conditions
●
Lockout devices must
not need excessive force to remove them
Mask fit test
A mask is
not able to protect you if it doesn't fit your face. It's that simple and
straight-forward. Certain masks, such as tight-fitting, must form a tight seal
with your face or neck to work properly. If your mask is not fitting your face
properly, polluted air can leak into your face, and you could breathe in risky
substances. So before you wear a tight-fitting mask at work, your employer must
ensure that half mask fit testing has been
carried out properly.
For more info:-Train the Trainer Traffic Control
course
Train the trainer safety courses
overhead crane operator certification
train the trainer course Ontario
Comments
Post a Comment